Daytona Motorcycle Grip Heater, Wrap-around Type, USB Type, Hot Grip, Wrap-around Type EASY2 USB (105mm) 15527

No need to replace the grip. These wrap-around heated grips are easy to attach and remove. No need to replace the dedicated grip, and USB connection eliminates wiring. Can also be used with a mobile battery. Energy-efficient 11W design. Features a thin, break-resistant film heater. The ON/OFF switch is integrated into the discreet USB terminal. The Daytona logo on the surface makes it non-slip. Compatible handlebar diameter: φ22.2 / Grip length: 110mm or larger Heated sheet: 95 x 105mm

This product is designed for use with a USB port (sold separately) with an output of 5V 2.1A or higher. If the port cannot output a stable 5V 2.1A, the heat output will be insufficient. Take special care when using the USB2 port (2.1A total output) with other devices.

Always wear thick winter gloves. Thin gloves can increase the risk of burns or low-temperature burns.

Avoid prolonged continuous use. Estimated usage time with a mobile battery: 1-1.5 hours at 6000mA/h (this may vary depending on the operating environment and battery degradation).

Installation may not be possible depending on the grip diameter.

No need to replace the grip, and USB connection eliminates the need for wiring. Easy-to-install wrap-around hot grip.

Power-saving 11W design for use with a mobile battery.

Thin, break-resistant film heater.

Compatible handle diameter: φ22.2 / Grip length: 110mm or longer.

Heated sheet: 95x105mm