Product Name: Stainless Steel Portable Thermos / Capacity: 0.58L / Material: 18-8 Stainless Steel (Powder Coated), Polypropylene, Silicone Rubber / BPA-Free / Made in China / Heat Retention: Above 80°C (6 hours) / Cold Retention: Below 6°C (6 hours) *Heat retention refers to the temperature of hot water poured into the thermos at room temperature of 20°C ± 2°C, when the water temperature reaches 95°C ± 1°C, the lid is closed, and the temperature is measured 6 hours later. *Cold retention refers to the temperature of cold water poured into the thermos at room temperature of 20°C ± 2°C, when the water temperature reaches 4°C ± 1°C, the lid is closed, and the temperature is measured 6 hours later. *For improved heat retention, add a small amount of hot (cold) water and allow to preheat (precool) for 1-2 minutes before adding beverages. ○This product is a beverage bottle. ○Do not use for any purpose other than its intended purpose. ○Cannot be used in the microwave, dishwasher or dryer. ○Do not place near fire. ○Do not boil water for cleaning. ○Keep out of reach of infants and young children. ○Do not drop or subject to strong impact as this may cause damage or leakage. ○Do not shake as this may result in unexpected injury or accidents. ○Do not shake or subject to strong vibrations as the liquid may boil over. ○Do not put dry ice in the bottle as this may cause the bottle to expand and result in damage or injury. ○Do not put too much liquid in the bottle as it may overflow when closing the lid. ○Make sure the silicone gasket is attached in the correct direction. ○When closing the lid, make sure it is closed horizontally. ○If the lid is not closed properly, the liquid may leak, so make sure it is closed securely. ○After closing the lid, turn the product upside down or on its side to check for leaks. ○To prevent any leakage, place it upright when putting it in a bag etc. ○Do not carry it with precision equipment such as mobile phones, computers or cameras as leakage may cause damage or malfunction. ○ Do not open the lid immediately after the main unit has been subjected to impact or vibration. ○ Do not open the lid while the main unit is tilted, as this may cause the drink to spill and stain things or cause burns. ○ When putting a carbonated drink in, hold the lid firmly and turn it slowly to release the gas before opening. ○ Do not open the bottle near precision equipment such as mobile phones, as this may cause the drink to spray out. ○ Due to the double-walled structure, even if the part you touch with your hand is not hot, the drink inside and the drinking spout may be hot, so please be careful not to get burned. ○ When drinking a hot drink, do not tilt the main unit suddenly and drink slowly, as the drink may come out with force and cause burns. ○ Do not leave the bottle in a high temperature location such as a car or in direct sunlight for an extended period of time. ○ Depending on usage conditions, the carbonation may escape more easily, for example if the temperature of the contents is high or the amount is small. ○ When putting in salty sports drinks or drinks containing vinegar, check the inside for rust or scratches before use, and wash it immediately after use. ○ Do not leave the bottle with the contents inside for an extended period of time, as this may cause rust and the drink to spoil. ○ If you leave the container filled with a hot drink for a long time, a vacuum will form inside as the contents cool. This may cause the lid to become stuck or the drink to spray out, resulting in burns or soiling. Please be careful. ○ If the lid becomes stuck, immerse the lid in hot water at approximately 50°C for about 1 minute to make it easier to open. ○ To prevent rust on the stainless steel, remove dirt and moisture as soon as possible, dry thoroughly, and store away from other metals. ○ Do not leave the container in water, as this may cause rust or damage. ○ Do not use cleansers or scrubbing pads when cleaning. ○ Do not use chlorine bleach, as this may cause rust. ○ If you notice a metallic smell when first using the container, fill it to the brim with 2 tablespoons of vinegar and lukewarm water, then rinse after 30 minutes. ○ If rust-like spots appear on the inside of the container, add lukewarm water and approximately 10% citric acid. After 2-3 hours, wash with a soft sponge and rinse thoroughly.
Heat and Cold Insulation Effectiveness. The double-walled vacuum structure provides excellent heat and cold insulation. It can also hold carbonated drinks. Keeps drinks hot above 80°C and cold below 6°C (for 6 hours).
Tough material. The bottle body is made of durable, rust-resistant 18-8 stainless steel. The surface is powder-coated to prevent scratches.
Lid with handle. The lid with handle makes carrying easy, and the covered spout makes it safe to use outdoors, even when it's prone to getting dirty.
Stress-free drinking experience. The smooth spout, with no protrusions or screws, fits small ice cubes and is designed to easily fill with water from a water dispenser. *Mouth diameter: 42mm, minimum inner diameter: 33mm
Designed for carafe use. The size and shape make it convenient not only for direct drinking but also for sharing drinks with several people.
