3pcs Ignition Coil+ 3pcs Iridium Spark Plug for Ford EcoSport 2018-2020 UF736+93593
Specifications
Length(cm): 33, width(cm): 24, height(cm): 5.5
Weight(kg): 0.87
Material: Iridium
Voltage: 12V
Connector Gender: Female
Terminal Gender: Male
Terminal Type: Blade
Spark Plug Material: Iridium
Thread Diameter(mm): 12.0
Thread Length(mm): 25.0
Manufacturer Heat Range: 8.0
Interchange Part Numbers
93593
Fitment
Compatible with Ford EcoSport 2018-2020 L3 1.0L, Fiesta 2014-2017 L3 1.0L, Focus 2015-2018 L3 1.0L
Features
Built to strict quality control standards 100% factory tested
IATF16949
100% Compatible with OEM Parts, meets Original Equipment Manufacturer (OEM) Standards
Direct replacement
100% pure copper windings in bobbins improve durability ,thermoplastic housing withstands heat stress for enhanced durability
Spark Plugs are using High-Performance Iridium metal, Much better than Nickel and Platinum
It's suggested that ignition coil and spark plug be replaced in a sychronized manner to lower the likelihood of common ignition system dysfunctions such as failure to start,engine vibration, misfiring, inadequate power ,spark plug fouling and poor fuel economy
Attention
How to Change Ignition Coils and Spark Plugs?1.Disconnect the old ignition coil and spark plugs2.Disconnect your battery’s negative terminal3.Locate the ignition coil and spark plugs to be replaced.4.Release the clip on the plug running into the side of coil.5.Use a wrench to unscrew the bolts holding the original coil in place6.Extract original ignition coil and spark plugs from the engine bay7.Swapping in the new ignition coil and spark plugs8.Prior to installation, compare the new coil to the old one9.Orient the new coil in the same direction10.Insert the bolts to hold the coil in place11.Activate the New ignition coil and spark plugs12.Connect the plug into the side coil13.Plug in ignition cables according to the order written on them.14.Reconnect the battery15.Start the vehicle to test the new ignition coil and spark plugs
Note
In preparation for the replacement, the vehicle should be turned off and cooled for a certain period of time before starting the replacement.pay attention to the cleanliness of the entire operation, must wipe the ignition coil around the dust and oil, if into the combustion chamber, will have serious adverse effects, try to wear gloves to operate.