Selector Kit NFJ Self-assembled 12 Amplifier/speaker "Bonneville Eaters" FX-AUDIO-

Voltage Compatibility】 When using electrical appliances, please note that they are designed for Japanese voltage specifications (90-110V), so if you use them with a different voltage, it may cause a malfunction.

【Plug Type】 Our products use Japanese plug types (A or B type). Please use a conversion adapter if necessary.

【Important Note on Transformers and Adapters】 A transformer adjusts voltage to match your device’s requirements. A conversion adapter only changes the plug shape and does not adjust voltage. Using only a conversion adapter without a transformer may result in damage to the product.

【Liability】 We are not responsible for malfunctions or damages caused by improper use, such as operating the product without a transformer. An unlikely amplifier/speaker selector kit Adopts high-strength 1.6mm thick glass epoxy board for durability. Compatible with BTL amplifier! 4-circuit completely independent design allows bidirectional connection Rational design that does not use any conductors The case can be reused due to the common board size with our other products and kits. This is a self-assembled kit of NFJ's original 1:2 amplifier/speaker selector "Bonneville Eaters". We manufacture and sell various audio-related products and self-made amplifier kits, and we have been honored to receive requests for an amplifier selector that allows for easy comparison and verification since many of our users own multiple of our products. Also, when we were developing an enclosure at our company, we needed a speaker selector, so when we looked for it in supplies, we found that it was surprisingly difficult to obtain one at a low price, as the price was unusually high and it was not compatible with BTL amplifiers. Therefore, we have newly developed ``Bonneville Eaters.'' You can prepare a case yourself and make a selector compatible with banana plugs, or you can combine two or more kits to support more switching, and you can also use it as a board for a line selector. The board itself does not use any wiring material, making it easy to understand and cleanly install. In addition, we have reduced the selling price of this kit as much as possible by changing the terminal parts in consideration of the intended use. The price is affordable, so please give it a try! [Assembly method] *Instructions are not included, but this is a very simple kit. (1) Prepare in advance three sets of two connected two-pole terminal blocks. (2) Insert all parts into the board as shown in the picture and solder. (Please change the direction of the terminal block according to the application.) ◎A quick note◎ - When using this kit alone, be careful not to use a hexagonal support to prevent short-circuiting. ・Please be careful as it will be difficult to use if the terminal block is oriented in the wrong direction. [Notes] *This product is not a finished product. The first photo is a completed example. *This is a DIY self-made kit, so you will need to do the soldering work yourself. *The warranty for initial defects on parts is one week. *However, only before assembly* *Due to the nature of this product being a self-made kit, there is no product warranty after assembly. *We will replace any parts that are damaged or missing before assembly, but we cannot provide any warranty support after assembly. *Depending on the arrival lot, the terminal screw may be a + screw or a - screw. [Product specifications] Brand: NFJ/FX-AUDIO- Kit contents: 1:2 amplifier/speaker selector board (high strength 1.6mm thick glass epoxy) x 1 Double pole terminal block x 6 pieces 4 circuit 2 contact push lock switch x 1 piece Switch cap [light gray] x 1 (already attached to the switch) Board size: 60mm x 80mm x 1.6mm Applicable wire: 14~22AWG (2~0.3sq) Wire stripping length: 4.5~5mm Weight: 28g