5PCS Micro/Type-c/Mini USB 18650 TP4056 Lithium Battery Charger Module Charging Board with Protection Dual Function Li-ion 5V 1A

Module features and parameters:

Instructions:

Note: When the battery is connected for the first time, there may be no voltage output between OUT+ and OUT-. At this time, the protection circuit can be activated by connecting the 5V voltage and charging it. If the battery is short-circuited from B+ B- and then connected, it also needs to be charged. Power off to activate the protection circuit. When using a mobile phone charger as input, note that the charger must be able to output 1A or more, otherwise it may not be able to charge normally

The TYPE C USB socket and the + - pads next to it are the power input terminals, which are connected to 5V voltage. B+ is connected to the positive electrode of the lithium battery, and B- is connected to the negative electrode of the lithium battery. OUT+ and OUT- are connected to the load, such as the positive and negative poles of the mobile booster board or other loads.

Connect the battery to B+ B-, insert the mobile phone charger into the USB socket, the red light is charging, and the blue light is full.

Note: When charging, the load on the OUT terminal should be disconnected. The positive and negative poles should not be wrongly connected. Please use them according to the specifications, otherwise it will be damaged directly.

1A lithium battery charging and protection integrated board two-in-one MICRO interface Module features and parameters: Interface: MICRO Voltage: 5V Charge cut-off voltage: 4.2V ±1% Charging current: 1000mA Battery over-discharge protection voltage: 2.5V Battery overcurrent protection current: 3A Board size: 2.8*1.7CM

TP4056 1A lithium battery charging source module Mini interface Module features and parameters: Interface: MINI Charging method: linear charging Charging current: 1A Accuracy: 1.5% Input voltage: 4.5V-5.5V Full charge voltage: 4.2V Can't be reversed Board size: 2.2*1.7CM

TP4056 1A lithium battery charging source module MICRO interface Module features and parameters: Interface: MICRO Charging method: linear charging Charging current: 1A Accuracy: 1.5% Input voltage: 4.5V-5.5V Full charge voltage: 4.2V Can't be reversed Board size: 2.2*1.7CM

1A lithium battery charging and protection integrated board two-in-one TYPE-C interface Module features and parameters: Interface: TYPE-C Voltage: 5V Charge cut-off voltage: 4.2V ±1% Charging current: 1000mA Battery over-discharge protection voltage: 2.5V Battery overcurrent protection current: 3A Board size: 2.8*1.7CM