Automobile Maintenance Tools Dent Repair Puller Door Hail Pit Sag Repair Kit Sheet Metal Puller

Material: metal Size: as shown in the figure Silver T-type puller +18 blue weight 200g How to use this paint-free dent repair kit: 1. Clean the dent with a clean wet cloth; 2. Put the glue stick into the glue gun, pull the trigger to let the glue stick enter the glue gun, and turn on the power supply to preheat for 5 minutes; 3. Use appropriate wire drawing gasket. A large dent requires a large tensile washer. (Note: The bigger it is. The greater the tension gasket, the greater the tension); 4. Pull the trigger and apply the drawing gasket with extrusion glue (the four holes of the gasket should be coated with hot melt adhesive); 5. Quickly place the wire drawing gasket coated with hot melt adhesive in the center of the dent, and gently press it until the glue cures and adheres (let the glue cool for about 8 minutes. Cooling time should be less than 10 minutes, in winter); 6. Align the T-shaped mending device, press the wire drawing gasket with hot melt adhesive, and pull the slide bar backward to pull up the dent; a 7. Check the circuit board. If the dent still exists, tap it gently with a flattened hammer or pen; 8. Clean the repair area with a clean wet cloth.